Owatrol DilunettISSN: 3297971408622

Solvent Free Paint Remover, Paint Stripper Safe For All Surfaces.  

Solvent free paint remover, paint stripper – strips up to 8 coats at one application removing paint, wax and varnish  

• Simple water rinse off.  
• Easy to apply gel consistency doers not run – ideal for vertical surfaces 
• Does not dry – long active working time (up to 12 hours)  
• Removes up to 8 coats of paint, varnish, stains and most anti-fouling paints  
• Strips ornate or intricate surfaces fast and easy  

Properties  

• Does not contain solvent or paraffin – non flammable.  
• Strips waxes, varnish, paint and most antifouling paints.  
• Coating becomes soluble with water (rinse with water).  
• Strips up to 8 coats of paint in 1 application.  
• Easy to apply, even on the most difficult or intricate surfaces  
• Does not evaporate – will not dry.  
• Softens the paint layers without supervision.    

Where to use  

• Use on wood (Except Oak, Chestnut, Parquet and Veneer), metals (except Aluminum), plastic, stone, cement …  
• Ideal for difficult to strip surfaces such as ornate, horizontal and vertical – doors, gates, stone etc.  
• Recommended for stripping large areas – non-flammable, does not dry out, remains active a long time. 
• Does not attack plastics, rubber, synthetic coating or fibreglass gel coats (GRP boats etc).    

Recommendations for use  

• Always test a small area first.  
• Wear protective gloves – rubber, nitrile. Use nylon/synthetic brushes.  
• Working time for stripping the finish varies from minutes to hours depending on the type of finish being removed (oil-based or water-based) and number of coats. Check the stripping action from time to time to establish when full removal of the finish(s) can be performed.  
• Always neutralise surface with Net-trol (diluted 4:1) after stripping.    

Directions for use  

• Apply a thick layer of Dilunett to surface to be stripped.  
• Allow to stand.  
• If the Dilunett paint remover starts to dry, apply a fine mist of water to keep active.  
• Scrub surface with stiff nylon brush and rinse with water using the highest pressure source available or use a pressure washer (max. 60 bar / 870 psi & not too close to the wood).  
• Using hot water makes stripping the paint easier.  
• After stripping wood, always neutralise with Net-trol, diluted 4:1 with water immediately after rinsing the Dilunett.  
• Refer to packaging for full instructions. 

Coverage : 4 m²/l 

Application tools : Brush - Stiff bristle 

Application temperature : 5°C to +35°C 

Working time : 5 min. to 12 h. 

Clean-up : Water